EPOS4 Compact 50/8 CAN
Part number 520885
The compact solution that is ready for connection, consisting of EPOS4 Module 50/8 and the matching connector board.
EPOS4 Compact 50/15 CAN
Part number 520886
The compact solution that is ready for connection, consisting of EPOS4 Module 50/15 and the matching connector board.
EPOS4 Module 50/8
Part number 504384
For brushed DC motors with encoders and brushless EC motors with Hall sensors and encoders up to 400 W.
EPOS4 Module 50/15
Part number 504383
For brushed DC motors with encoders and brushless EC motors with Hall sensors and encoders up to 750 W.
With the BG 95 dPro Dunkermotoren is nominated for the Best of Industry Award 2019 in the category drive technology. Vote now for the highly integrated servo motor BG 95 dPro. The peak output power of 3.900 W at a low voltage of up to 60 V is what sets this power pack apart. Dunkermotoren is known for the consistent integration of electronics in the motor - as it is the case with the BG 95 dPro, which also integrates all electronics in the drive. The difficulty for users in matching each individual component to the other is completely eliminated with Dunkermotoren. Thanks to the modular design principle, the drive components - motor, gearbox, brake and encoder - are already configured and matched as a complete drive.
If you also think that the BG 95 dPro deserves an award - then vote for it: maschinenmarkt.de/best-of-industry/voting
The IDEA™ family of programmable Stepper Motor Controllers uses an intuitive patent-pending Graphic User Interface (GUI) which greatly simplifies set up and use in the machine design process. Units are available in either USB or RS-485 communication. In addition to the stand-alone models shown, drives are available integrated on motor and linear actuator assemblies.
Stand-alone drive unit or integrated directly onto a linear actuator
Programming done through Graphic User Interface (GUI)
Automatic population of motor and drive parameters
Programmable Speed / Current / Accel-Decel / Current Boost / Interrupts / I/O
Encoder Input / Stall Detection with Compensation / Position Verification
USB or RS-485 Communication protocols
Movement Profile Plotter
Interactive Program Debug Feature